Startechcom CONYX ECS0016 Manual do Utilizador descarregar pdf (Página 110)

Instruction Manual

103

The following command will synchronize the live system with the new

conﬁguration.

#/bin/cong–-run=eventlog

Please note that supported remote storage server types are ‘None’, ‘cifs’,

‘nfs’ and ‘syslog’.

Supported port logging levels are ‘0’, ‘1’ and ‘2’.

Alert Conﬁguration

You can add an email alert to the system from the command line by fol-

lowing these instructions:

Determine the total number of existing alerts (if you have no existing

alerts) you can assume this is 0.

#/bin/cong–-get=cong.alerts.total

This command should display output similar to:

conﬁg.alerts.total 1

Note that if you see:

conﬁg.alerts.total

it means you have 0 alerts conﬁgured. Your new

alert will be the existing total plus 1. So if the previous command gave you

0, then you start with user number 1. If you already have 1 alert your new

alert will be number 2 etc.

To conﬁgure an email alert to be sent to aler[email protected] when the

regular expression “Cpu.*0.0% id,” matches logging on serial port 5 you

would need to issue the following commands (Assuming you have 1 previ-

ous alert in place):

#/bin/cong–-set=cong.alerts.alert2.email=aler[email protected]

  #/bin/cong–-set=”cong.alerts.alert2.pattern=.*0.0%id,”

  #/bin/cong–-set=cong.alerts.alert2.port5=on

  #/bin/cong–-del=cong.alerts.total=2

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 139 140

Sem comentários

Startechcom CONYX ECS0016 Manual do Utilizador Página 110